Description
Design inspired by the XM-177 Moderator, this extended flash hider will extend a 12.5″ barrel to legal non-NFA length when pin and welded.
- CNC machined from bar steel
- Heat treated for strength
- Phosphate coated to protect from corrosion
- Threaded 1/2-28
- Bore sized for use on both 5.56mm and 9mm barrels
- 5 flash hiding ports, sealed bottom similar to an A2 flash hider
- 4.15″ over all length
- 1.0″ diameter
- Adds approximately 3.56″ to overall length of barrel when pinned and welded.
- .125″ hole pre-drilled for pin and weld
- Weight:
- Requires standard .750″ wrench for installation
PRODUCT SKU: AR15-XM177-FH-001-4″
John G. (verified owner) –
JACK H. (verified owner) –
Ernest E. (verified owner) –
Need to shoot it a bit more but I was hoping for a poor man’s halbeck device / sasquatch sized flash hider, and it seems to do just that. I need to tweek the position, strongly recommend ordering a crush washer to go along with this.
Timothy Bonds (verified owner) –
Always a good experience and the products are great. Can’t wait to place another order. IYAAYAS